Cut list
The cut list lays the panels out on sheets, for each material separately. Specification → Details → Cut list.
Settings per material
Section titled “Settings per material”For each material set:
- Cut method — Panel saw or CNC router,
- Kerf — how much material the cut takes (mm),
- Edge trim — how much is trimmed off the sheet edge before cutting (mm).
The layout is recalculated right away.
Sheets
Section titled “Sheets”Below the settings is every sheet: Sheet 1/3, the panel layout and the yield. Grain is respected — a grain panel isn’t turned across the grain.
If a panel doesn’t fit the sheet (it is larger than the sheet), the cut list lists it separately.
Remnants
Section titled “Remnants”If you have remnants, the cut list uses them before full sheets. A remnant sheet is labelled remnant W×H. When there aren’t enough remnants, full sheets are added and you get a warning.
Export
Section titled “Export”- CSV — a table for cutting software or your supplier,
- DXF for CNC — one DXF per panel and machined face, in a ZIP; the machining is in the layer names.
See PDF and CSV export.
Locked specification
Section titled “Locked specification”While the specification is locked, the cut settings can’t be changed. See Locking the specification.